Starting a lawn mower may seem like a simple task , but it ’s all important to do it correctly to assure your mower runs smoothly and expeditiously . Whether you have a ride - on mower or a push button mower , the outgrowth is generally similar but with some variant . In this usher , we will take the air you through the steps to start your lawn lawn mower efficaciously .
Check the Fuel and Oil Levels
Before start your lawn lawn mower , it ’s crucial to check the fuel and oil colour levels . Make certain there is enough gasolene in the tank and that the crude oil point is adequate . run a lawn mower with depleted fuel or oil colour can damage the engine and affect its performance .
Inspect the Spark Plug
Another important step is to visit the discharge plug . Ensure that it is clean and in good condition . If you acknowledge any build - up or damage , substitute the spark quid before attempt to initiate the lawn mower .
Prime the Engine
Next , ground the engine by press the primer incandescent lamp several times . This action aid to redeem fuel to the engine and facilitate the starting process . Be sure not to over - flush , as it can inundate the locomotive engine .
Set the Choke
Adjust the Throttle
Before starting the lawn mower , adjust the throttle to the appropriate setting . Typically , the accelerator pedal should be set to a medium speed for startup . Avoid place it too mellow or too low , as it can bear on the engine ’s carrying out .
Hold the Safety Lever
Most lawn mower have a safety lever that must be held down while starting the locomotive . This lever tumbler is a rubber characteristic that prevent inadvertent starting . Make certain to transfix the lever firmly while starting the mower .
Engage the Blade Control
If you have a take the air - behind lawn mower , engage the blade control before set off the locomotive engine . This action prepares the mower for operation and ensures that the blades are ready for cutting grass expeditiously .
Insert the Key and Turn It
For ride - on mowers , stick in the Florida key into the kindling and turn it to start the engine . Hold the key in the starting berth until the engine turns over and starts operate swimmingly . resign the key once the engine is running .
Pull the Starter Rope
For button lawn mower , locate the starter R-2 and give it a house perpetrate to start up the engine . Repeat the pulling move as needed until the locomotive engine starts . Be sure to pull the roach swimmingly and equally to obviate any issue .
Listen for Engine Sounds
As the engine starts , listen for any strange sounds or vibration . An abnormal noise could indicate a problem with the engine or components . If you notice anything out of the ordinary , close off the mower and inspect it before continuing .
Warm Up the Engine
Once the engine starts , allow it to warm up up for a few minutes before plight the blades and starting the mowing process . This step helps the engine contact optimal operating temperature and ascertain smoother operation .
Shut Off the Engine Properly
Caroline Bates
